Document Type

Data Set

Publication Date

8-1-2019

Abstract

Corresponding data set for Tran-SET Project No. 18ITSTSA03. Abstract of the final report is stated below for reference:

"Inspired by the fact that there is an immense amount of renewable energy sources available on the roadways such as mechanical pressure and frictional heat, this study presented the development and implementation of an innovative charging technique for future electric vehicles (EVs) by fully utilizing the existing roadways and the state-of-the-art nanotechnology and power electronics. The project introduced a novel wireless charging system, SIC (Smart Illuminative Charging), that uses LEDs powered by piezoelectric nanomaterials as the energy transmitter source and thin film solar panels placed at the bottom of the EVs as the receiver, which is then poised to deliver the harvested energy to the vehicle’s battery. Through the project, the energy-harvestable 2D nanomaterials (EH2Ns) were tested for their mechanical-to-electrical energy conversion capabilities and the relatively large-area EH2N samples (2cm x 2cm) produced high output voltages of up to 52mV upon mechanical pressure. An electrically conductive glass fiber reinforced polymer (GFRP) was developed to be used as physical support in the integrated SIC system. Furthermore, a lab-scale prototype device was developed to testify the mechanism of illuminative charging. The project team was able to prove the feasibility of SIC concept and the start to end conversion efficiency was calculated to be 40%. The project team also provided field implementation recommended framework based on the results from the small-scale prototype developed. The framework discussed how the developed SIC can be implemented in the field and what are the expected outcomes. The team recommended inserting the EH2N embedded in the GFRP, the LEDs and the needed circuitry in the wheel path of the vehicles on the pavement by cutting a sawtooth compartment with a width of 18’’ and a length of 8’ every couple of miles. On the vehicle, a PV array will be placed on the underside between the wheel wells of each side of the EV to capture the illumination from the LEDs embedded in the roadway. The detailed strategy is presented in this report."

Comments

Tran-SET Project No. 18ITSTSA03

COinS