Identifier

etd-04152004-114700

Degree

Master of Science in Civil Engineering (MSCE)

Department

Civil and Environmental Engineering

Document Type

Thesis

Abstract

The use of high-speed data acquisition systems, inexpensive and reliable transducers, and better models of interpretation have combined to make elastic wave tomographic imaging of geotechnical engineering systems easier to accomplish both in the laboratory and in the field. An important application of these developments is that the evaluation of states of effective stress in soils using images of elastic wave velocity distribution. As a consequence, it is possible to experimentally estimate the state of induced and in-situ effective stresses and to compare these results with established models of stress distribution based on the theory of elasticity (e.g., Boussinesq’s solution). The effective stress versus shear wave velocity relationship follows a Hertz’ model. The parameters for this relationship are calibrated by testing the dry sand in both a modified triaxial cell and an oedometer cell hosting bender elements. The long term objective of this research is to obtain a tomographic image of the states of in-situ and induced stresses in clean, dry sand underneath a model footing. The post calibration test program consists of a test cell that is capable of yielding a Ko-state of stress condition while allowing independent control of simulated overburden pressure and bearing pressure. The elastic waves will be generated and received using bender elements (i.e., bimorph piezoceramic crystals). Justification of the travel time data from the test cell is made possible by a numerical integration of the Boussinesq solution for our stress conditions. Furthermore, velocity field images are presented as well as recommendations for improvements.

Date

2004

Document Availability at the Time of Submission

Release the entire work immediately for access worldwide.

Committee Chair

Dante Fratta

DOI

10.31390/gradschool_theses.3710

Share

COinS